What is Flow Forming Wheel

Flow Forming process, strictly speaking, it also belongs to the branch of "casting". The wheel produced by its process includes two different technologies: Flow Forming and casting. Firstly, the disk shape and rough embryo of wheel rim are produced by "low-pressure casting". Before this step, it is exactly the same as the general casting method. The rough embryo looks like a wheel hub with short width and thick inner rim, It looks short and fat.

Next, the rough embryo must be sent to the heating furnace and heated to a high temperature of about 400 degrees. Because it is less than the melting point temperature of the aluminum alloy, the aluminum alloy rough embryo still remains in a solid state and only softens slightly to the temperature that can be processed. In "Flow Forming", the side of the rim rough embryo is pressurized and extended by a high-pressure roller. In short, The principle of "Flow forming" is like "hand pulling ceramic embryo". While rotating, pressure is applied to the side to lengthen and thin the aluminum alloy embryo. Due to the re molding of the aluminum alloy under high pressure, the density of the aluminum alloy during processing can be improved and the internal crystal structure of the aluminum alloy can be closer. In this regard, it is pressed under high pressure compared with "forging", The method and principle of improving metal density are the same. Because the metal material is stronger, the strength demand can be met with a lighter and thinner rim body.

1. Pre-sale service

A.You can get a sample to inspect the quality or send us your samples so that we make the sample for your confirmation.

2. Sale service

A. We have Strict car alloy wheel rim quality Control System.

B. Before the delivery, we support our clients to arrange the third party to inspect the quality of the goods,If mass production is not same as approved sample, we will take the fully responsibility.
C. If we do not ship on time, we will make up your loss.
3. After-sale Service:
A. Take photos or videos of the problems and send to us;
B.Send back the problem goods, or we will sent our representative for inspection.
When we comfirmed its our problem, after communication with customers, we will return the amount of problem goods, or cut this amount in next order, and make new production and sent immediately, or sent together with next order according to customers’ requirement.

Quality Standard

Our products have passed the evaluations of German TUV certification and Japanese VIA certification. Our production and operation strictly conforms to ISO9001/TS16949 quality system. Currently we can produce various sizes of alloy wheels from 13 inch to 34 inch